CP30 INSTRUCTION MANUAL
28
Roger Beep
The Roger Beep setting applies a short tone to the end of your transmission to
alert the receiving party that your transmission has ended.
To Enable or Disable the Roger Beep Tone:
1. Hold the
MENU
F
key to access the menu.
2. Rotate the Channel Selector knob or press the keys until
RGBEEP is displayed.
3. Press the
MENU
F
key.
4. Rotate the Channel Selector knob or press the keys to select
OFF or ON.
5. When the desired setting is displayed, press the
MENU
F
key to exit the
menu or wait a few seconds for the menu to time-out.
Microphone Gain
The microphone gain boosts your voice input level at the microphone. If you are
quietly spoken or are operating in a quiet environment where you cannot talk at
a normal voice level, you can increase the microphone gain to make your voice
sound louder on receiving radio(s).
To Adjust Microphone Gain:
1. Hold the
MENU
F
key to access the menu. The last selected menu item
will be displayed.
2. Rotate the Channel Selector knob or press the keys until
MIC G is displayed.
3. Press the
MENU
F
key.
4. Rotate the Channel Selector knob or press the keys to select
a microphone level from 0 to 9. The default setting is 0.
5. When the desired setting is displayed, press the
MENU
F
key to exit the
menu or wait a few seconds for the menu to time-out.
To Next Page
Loading...
