GME CP30 - LCD Backlight; Display Options

CP30 INSTRUCTION MANUAL
32
4. Rotate the Channel Selector knob or press the keys to select
level of boost LO-MEDIUM-HI.
5. When the desired level is displayed press the
MENU
F
to exit or wait a
few seconds for the menu to timeout.
LCD Backlight
The LCD is backlit for easy viewing in low light conditions. Whenever a key is
pressed the backlight will switch on. After 5 seconds of inactivity it will switch o
again automatically to conserve power. The backlight settings can be adjusted in
the menu.
To Adjust the Backlight Settings:
1. Hold the
MENU
F
key to access the menu. The last selected menu item
will be displayed.
2. Rotate the Channel Selector knob or press the keys until
BACKLT is displayed.
3. Press the
MENU
F
key.
4. Rotate the Channel Selector knob or press the keys to select
ON, OFF or AUT.
• ON: The backlight is always On
• OFF: The backlight is always O
• AUT: The backlight will switch on when a key is pressed but will
switch o automatically after 5 seconds.
5. When the desired setting is displayed, press the
MENU
F
key to exit the
menu or wait a few seconds for the menu to time-out.
Display Options
The display options allows you to choose the information that is displayed on the
LCD in the space below the channel number. The default setting is S-MET which
displays the incoming signal strength in logarithmic format using values from 0-9+
To Select a Dierent Display Option:
1. Hold the
MENU
F
key to access the menu. The last selected menu item
will be displayed.