GME CP30 - Page 56

CP30 INSTRUCTION MANUAL
52
8. Repeat steps 4 & 5 to edit the Alpha Name. When the desired label is
displayed, hold
MENU
F
to save. The Ident will ash 3 times to conrm it
has been saved.
9. Press
CALL
LOCK
to return to the CALL sub-menu.
10. Press
CALL
LOCK
again to return to normal operation.
Saving a New SelCall Ident in Your Contact List
1. Press
CALL
LOCK
to enter the CALL Menu.
2. Rotate the Channel Selector knob or press the keys to cycle
to the SAVED option then press
MENU
F
to select.
3. Rotate the Channel Selector knob or press the keys (if
necessary) to cycle through your contacts until FREE is displayed. This
indicates the next available empty contact memory.
4. Hold
MENU
F
to select this location.
• If the edit eld displays ‘00000’ and the right-hand digit is
ashing, the radio is in Ident mode.
• If the edit eld is blank and the left-hand character is ashing,
the radio is in Alpha mode.
5. Rotate the Channel Selector knob or press the keys to select
the desired number or character in the ashing position.
6. Press
MENU
F
to advance to the next position.
7. Repeat steps 5 & 6 to enter all 5 Ident digits or up to 6 Alpha
characters, then hold
MENU
F
to save. The eld will ash 3 times to
conrm it has been saved.
8. Briey press
MENU
F
to toggle between Ident and Alpha modes.
9. Hold
MENU
F
to edit the new eld.
10. Repeat steps 5, 6 & 7 to enter the desired characters or numbers into
the eld.
11. Hold
MENU
F
to save. The eld will ash 3 times to conrm it has been
saved.
12. Press
CALL
LOCK
to return to the CALL sub-menu.
13. Press
CALL
LOCK
again to return to normal operation.