GME CP30 - Page 63

59
CP30 INSTRUCTION MANUAL
To Scan in the Quiet Mode
1. Press
MENU
F
then
SCAN
OS/GS
to select the desired Scan group (OPEN1,
OPEN2 or GROUP only).
2. Ensure the channels you wish to scan are stored in the selected scan
memory. The icon should be visible on those channels.
3. From these channels, select the ones you wish to remain Quiet and
hold the
QUIET
PWR
key to tag them for QUIET operation (Q is displayed).
4. Press the
SCAN
OS/GS
key. The radio will begin scanning and the icon
will animate.
5. Briey press the
QUIET
PWR
key to activate the QUIET mode. The Q icon will
appear to conrm the radio is scanning in the QUIET mode.
Receiving Signals While Scanning in the Quiet Mode
If a signal is received on an open channel, the scan will pause while the channel
is busy to allow you to hear the signal and will resume after the channel becomes
clear. If you are scanning in Group Scan mode, the radio may switch between the
open channel and the Priority Channel – this is normal.
If a signal is received on a Quiet channel but your SelCall Ident is not detected, the
signal will be ignored and scanning will continue.
If a signal containing your SelCall Ident is received on any channel (either Open or
Quiet), the scan and QUIET modes will be cancelled and the receiver will stay on
the busy channel. The alarm will then beep to alert you to the call and the caller’s
Ident or Alpha Name will be displayed. The channel will now be open for normal
communications.
TIP: To ensure reliable SelCall detection when scanning in the Open Scan mode,
it is recommended that you restrict the number of channels in the Scan group to
less than 20.