Startup
20 3A5085C
Startup
TurboControl allows for performance
adjustment of the sprayer. To reduce
over-spray, always start at lowest setting and
increase to the minimum setting required to
provide the desired finish.
1. Turn TurboControl to lowest setting.
2. Turn ON/OFF switch to ON position.
NOTE: ProContractor and ProComp models
in AutoStart setting will automatically turn off
when not actively spraying. Sprayer will start
upon re-triggering of HVLP Edge II Plus gun.
Turn switch to ON position if AutoStart is not
desired. In ON mode, unit will still shutdown
after 3 minutes of non-use. Sprayer will start
upon re-triggering of gun.
NOTE: For AutoStart to function, use
components provided with sprayer and Edge
II Plus gun. For replacement parts, see pages
38-41.
3. Verify trigger slide is in SPRAY position
(A).
ti30685a
ti30686a
ti31187a
To Next Page
Loading...
Need help?
General
