USING GWN7602 IN DEFAULT STANDALONE MODE
The GWN76XX can be used with the default Standalone mode, or in Slave mode where it will be managed
by another GWN76XX Master, or from GWN Management platforms.
Note: The GWN7602 does not have a Web GUI and cannot act as a true Master/Standalone AP like
the other GWN76XX models, Therefore it needs to be managed from another controller like GWN
Cloud or a GWN76XX Master AP.
This section will describe how to use the GWN7602 in the default standalone mode.
Connect to GWN7602 Default Wi-Fi Network
GWN76XX can be used as standalone access point out of box, or after factory reset with Wi-Fi enabled
by default.
After powering the GWN7602 and connecting it to the network, GWN7602 will broadcast a default SSID
based on its MAC address GWN [MAC’s last 6 digits] and a random password.
Note that GWN76XX’s default SSID and password information are printed on the MAC tag of the unit as
shown on the below figure.
Figure 5: MAC Tag Label
To Next Page
Loading...
Need help?
General
