● IP-Based: Forward using IP address
MLD Version Select the MLD Version.
Report Suppression
Enable or disable the switch to handle MLD reports
between router and host, suppressing bandwidth used by
MLD.
VLAN Displays the selected VLAN
MLD Snooping Click on the toggle button to enable MLD Snooping for the selected VLAN.
MLD Snooping Querier Click the toggle button to enable the MLD Snooping Querier.
MLD Snooping Querier Version Select from the drop-down list the MLD Snooping Querier Version.
Router Port Auto-Learning Click on the toggle button to learn router port by MLD query.
Port Fast Leave
Select Enable/Disable Fast Leave feature for the desired port.
Note: If Fast Leave is enabled for a port, the switch will immediately remove this port from the
multicast group upon receiving MLD leave messages.
Query Robustness
Set a number which allows tuning for the expected packet loss on a subnet.
The valid range is 1-7
Query Interval (s) Set the interval of querier send general query.
Query Max Response Interval (s)
It specifies the maximum allowed time before sending a responding report.
Note: The valid range is 5-20 in seconds.
Last Member Query Count
After quering for specified times and still not receiving any response from the subscribed
member, GWN7800 series switches will stop transmitting data to the related GE port(s).
Note: The valid range is 1-7
Last Member Query Interval (s)
Set The maximum time interval between counting each member query message with no
responses from any subscribed member.
Note: The valid range is 1-25 in seconds
To Next Page
Loading...
Need help?
General