DNS Server 1 Enter the DNS server 1 address for static IP settings.
DNS Server 2 Enter the DNS server 2 address for static IP settings.
If “IP Method” is set to “PPPoE”
User Name Enter the user name to connect via PPPoE.
Password Enter the password to connect via PPPoE.
If “IP Method” is set to “DHCP”, “Static” or “PPPoE”
Layer 2 QoS 802.1Q/VLAN Tag
Assign the VLAN tag of the layer 2 QoS packets for the LAN port. The default value is
VLAN Tag). The valid range is between 2 and 4094.
Layer 2 QoS 802.1p Priority Value
Assign the priority value of the layer 2 QoS packets for the LAN port. The default valu
The valid range is between 0 and 7.
LAN (when Method set to “Route”)
IP Address Enter the IP address. The default setting is 192.168.2.1
Subnet Mask Enter the subnet mask address. The default setting is 255.255.255.0.
DHCP Server Enable Enable or disable DHCP server capability. The default setting is “Yes.
DNS Server 1 Enter DNS server address 1. The default setting is 8.8.8.8
DNS Server 2 Enter DNS server address 2. The default setting is 208.67.222.222.
Allow IP Address From Enter the DHCP IP Pool starting address. The default setting is 192.168.2.100.
Allow IP Address To Enter the DHCP IP Pool ending address. The default setting is 192.168.2.254.
Default Gateway Configure the default Gateway assigned by the DHCP server.
Default IP Lease Time Enter the IP lease time (in seconds). The default setting is 43200.
Layer 2 QoS 802.1Q/VLAN Tag
Assign the VLAN tag of the layer 2 QoS packets for the LAN port. The default value is
VLAN Tag). The valid range is between 2 and 4094.
Layer 2 QoS 802.1p Priority Value
Assign the priority value of the layer 2 QoS packets for LAN port. The default value is
valid range is between 0 and 7.
IPv6 Address
WAN (when “Method” is set to “Route”) / LAN
(when “Method” is set to “Switch”)
IP Method Select Auto or Static. The default setting is Auto
If “IP Method” is set to “Static”
IP Address Enter the IP address for static IP settings.
IP Prefixlen Enter the Prefix length. Default is 64
DNS Server 1 Enter the DNS server 1 address for static settings.
DNS Server 2 Enter the DNS server 2 address for static settings.
To Next Page
Loading...
Need help?
General
