Grandstream Networks GXW45 Series User Manual

Figure 20: Add Bind New MAC Address Bind
The user needs to set the device MAC address and the IP that will be bound to it (the IP address needs to be within the GXW450X DHCP range).
In order to bind a batch of listed MAC addresses, the user needs to check first the MAC addresses to bind and click on . A confirma
popup will be shown, click to bind the addresses.
Figure 21: Batch Add MAC Address Bind
After Clicking “OK” to confirm the binding, the “Bind Status” will change from “Unbind” to “Binding”.
802.1X Settings
IEEE 802.1X is an IEEE standard for port-based network access control. It provides an authentication mechanism to the device before the device ca
access the Internet or other LAN resources. The GXW450X supports 802.1X as a supplicant/client to be authenticated. The following diagram and
show the GXW450X uses 802.1X mode “EAP-MD5” on the WAN port as the client in the network to access the Internet.
Figure 22: GXW450X Using 802.1X as Client

Grandstream Networks GXW45 Series Specifications

General

Brand	Grandstream Networks
Model	GXW45 Series
Category	Gateway
Language	English