CS500/IS200-UM-251-9370 4-1
4. INSTALLING THE SOFTWARE
4. INSTALLING THE SOFTWARE
The procedure outlined below is based on the requirement that you are logged on to Windows with administrator
rights. Consult your Windows 2000 or Windows XP manual for more information.
4.1 Installing the Driver Software for Windows 2000
The following procedure assumes that you are using the CS500-11 as part of your system, and that you are
using the USB interface. If you are using the IEEE 1394 interface, GRAPHTEC CS500-11 IEEE 1394 SBP2
Device will be displayed where CS500-11 is displayed when the USB interface is used. The scanner name
displayed in the windows is the name of the scanner connected to the computer (CS500-11 is used in this
section).
(1) Connect the scanner to the computer, and turn on the computer’s power. Insert the CD-ROM disk
(included with your computer) into the CD-ROM drive of the computer after Windows has started up,
and then turn on the scanner’s power.
(2) The message below appears.
(3) Next, the Found New Hardware Wizard appears.
(4) Click the Next button to proceed to the menu for installing the driver.
To Next Page
Loading...
