GRAPHTEC CS500 Series - Left Side Cover; Top Cover Assembly

CS500/IS200-UM-251-9370 8-2
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.3 Top Cover Assembly
Detaching the top cover
(1) Detach the right and left side covers (see Sections 8.1 and 8.2).
(2) Remove the four M3L10 cap screws and the two M3L14 cap screws on both sides of the plate.
(3) Detach the top cover assembly from the scanner unit as shown below.
M3L14 Cap
Screw
M3L14 Cap
Screw
M3L10 Cap
Screw
M3L10 Cap
Screw
Top Cover
Assembly
Reattaching the top cover
(1) Reattach the top cover in the reverse order in which it was detached.
8.4 Front Guide Assembly
Detaching the front guide assembly
(1) Detach the right and left side covers (see Sections 8.1 and 8.2).
(2) Remove the four M3L6 binding head screws holding the front guide assembly from each side.
(3) Detach the front guide assembly as shown below.
M3L6 Binding
Head Screw
M3L6 Binding
Head Screw
Front Guide Assembly
Reattaching the front guide assembly
(1) Reattach the front guide assembly in the reverse order in which it was detached.
When reattaching the front guide assembly, make sure that the front guide assembly does not touch the front drive
roller.