GRAPHTEC CS500 Series - Front and Rear Paper Detection Sensors

CS500/IS200-UM-251-9370 8-10
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.11 Front and Rear Paper Detection Sensors
Detaching the front paper detection sensor
(1) Detach the right and left side covers (see Sections 8.1 and 8.2).
(2) Detach the front guide assembly (see Section 8.4).
(3) Remove the M3L10 binding head screws holding the front paper detection sensor.
(4) Disconnect the front paper detection sensor cable from the connector and then detach the front paper
detection sensor.
M4L10 binding
head screw
Right side top
cover sensor
M4L6 binding
head screw
M3L6 binding
head screw
M3L6 binding
head screw
M3L10 binding
head screw
M3L10 binding
head screw
Rear paper
detection sensor
Front paper
detection sensor
Right side top cover
sensor bracket
Left side top
cover sensor
Left side top cover
sensor bracket
Detaching the rear paper detection sensor
(1) Detach the rear cover (see Section 8.5).
(2) Remove the M3L10 binding head screws holding the rear paper detection sensor.
(3) Disconnect the rear paper detection sensor cable from the connector and then detach the rear paper
detection sensor.
Reattaching the paper detection sensors
(1) Reattach the paper detection sensors by reversing the sequence of steps in which they were detached.