GRAPHTEC CS500 Series - IEEE 1394 Board (Onlry for the IEEE1394 model)

CS500/IS200-UM-251-9370 8-20
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.19 IEEE 1394 Board (Onlry for the IEEE1394 model)
Detaching the IEEE 1394 board
(1) Detach the right and left side covers (see Sections 8.1 and 8.2).
(2) Detach the front guide assembly (see Section 8.4).
(3) Remove the two M3L6 binding head screws and the one M2L6 binding head screw holding the IEEE
1394 board.
Data power boardData power board
CIS power board
CIS power board
Switching power supply boardSwitching power supply board
Data controller boardData controller board
IEEE1394 boardIEEE1394 board
M2L6 binding head screwM2L6 binding head screw
M3L6 binding head screwM3L6 binding head screw
(4) Detach the IEEE 1394 board from the data controller board.
Reattaching the IEEE 1394 board
(1) Reattach the IEEE 1394 board in the reverse order in which it was detached.
(2) When replacing the IEEE 1394 board, perform the software adjustment to input the MAC address for
the IEEE 1394 board (See "Replacing the IEEE 1394 board" in Section 9.3).