CS500/IS200-UM-251-9370 8-6
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.8 Drive Rollers
Detaching the front drive roller
(1) Detach the right and left side covers (see Sections 8.1 and 8.2).
(2) Detach the front guide assembly (see Section 8.4).
(3) Detach the drive roller belt and the pulley from the drive roller (see Section 8.7).
(4) Detach the E-ring holding the drive roller.
(5) Detach the two bearings holding both ends of the drive roller.
(6) Remove the two M3L6 binding head screws holding the left side top cover sensor bracket.
(7) Disconnect the left side top cover sensor cable from the connector and then detach the left side top
cover sensor together with the bracket.
(8) Slide the drive roller to the left, lift up the drive roller from the right side, and then detach it.
Rear drive roller
Front drive roller
Left side top
cover sensor bracket
M4L6 binding
head screw
Bearing
E-ring
Detaching the rear drive roller
(1) Detach the right and left side covers (see Sections 8.1 and 8.2).
(2) Detach the rear cover (see Section 8.5).
(3) Detach the drive roller belt and the pulley from the drive roller (see Section 8.7).
(4) Detach the E-ring holding the drive roller.
(5) Detach the two bearings holding both ends of the drive roller.
(6) Slide the drive roller to the left, lift up the drive roller from the right side, and then detach it.
To Next Page
Loading...
