CS500/IS200-UM-251-9370 8-7
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
Reattaching the drive rollers
(1) Reattach the drive rollers by reversing the sequence of steps in which they were detached.
(2) The front drive roller and the rear drive roller are different.
When installing a drive roller, check the mark on it to make sure that you have the correct one.
Install the drive roller with
this mark at the front.
Install the drive roller with
this mark at the rear.
(3) Adjust the drive belt tension (see Section 8.9).
To Next Page
Loading...
