CS500/IS200-UM-251-9370 5-6
5. DAILY MAINTENANCE
5.6 Calibration
Calibrate the scanner if scanning quality is observed to deteriorate, with scanned results such as those
described below:
• The scanned image is distorted
• Areas of uneven color appear in the scanned image
• Other unsatisfactory results (but not including problems related to media quality, such as folds, wrinkling, or
paper curling)
• Handle the calibration sheet with care so that it does not get bent. To prevent soiling, store it in its special storage
box. The calibration sheet cannot be used if it is bent or soiled.
• The calibration sheet is a paper product. Do not attempt to clean it with any type of liquid cleaner.
• The calibration sheet is a consumable item. Replacement sheets can be purchased from your sales representative
or nearest Graphtec vendor.
Preparation and checks
Recommended usage environment
• Monitor: 1024 x 768 pixels, High Color or better resolution
A low-resolution monitor will make it difficult to discern any problem areas.
Launching the Scanner Adjustment Program
(1) Connect the scanner to the PC and switch on the scanner. Switch on the PC.
(2) Install Scanning Master 21+ (OPS112) if it is not already installed.
(3) Click the Start button, then select Programs > Scanning Master 21+ > Scanner Adjustment.
(4) Click Scanner Adjustment to launch the Scanner Adjustment program.
To Next Page
Loading...
