GRAPHTEC CS500 Series - Pinch Roller Units

CS500/IS200-UM-251-9370 8-19
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.18 Pinch Roller Units
Detaching the front pinch roller units
(1) Detach the pinch roller covers (see Section 8.16).
(2) Remove the two M3L6 binding head screws holding the four pinch rollers unit assembly.
Detach the four pinch rollers unit assembly from the top cover assembly.
M3L6 binding head screw
M3L6 binding head screw
M3L6 binding head screw
Front center pinch rollers unit assembly
(3) Remove the four M3L6 binding head screws holding the center pinch rollers unit assembly.
Detach the center pinch rollers unit assembly from the top cover assembly.
Detaching the rear pinch roller units
(1) Detach the pinch roller covers (see Section 8.16).
(2) Remove the two M3L6 binding head screws holding the four pinch rollers unit assembly.
Detach the four pinch rollers unit assembly from the top cover assembly.
M3L6 binding head screw
M3L6 binding head screw
M3L6 binding head screw
Five pinch rollers unit assembly
Four pinch rollers unit assembly
(3) Remove the four M3L6 binding head screws holding the fi ve pinch rollers unit assembly.
Detach the fi ve pinch rollers unit assembly from the top cover assembly.
Reattaching the pinch roller units
(1) Reattach the pinch roller units in the reverse order in which they were detached.