CS500/IS200-UM-251-9370 10-11
10. ADJUSTMENTS USING THE SOFTWARE
(6) Click the "Check" button, then click the "Set" button. The following dialog box will appear.
Click the "OK" button, then press the " " button while pressing the "Stop" button. Reposition the
42-inch test chart on the scanner.
(7) Click the "Scan" button to redisplay the scanned image. Confirm that the dark rectangle is between 6
and 11 pixels from the window edge.
(8) When the scanned image is between 6 and 11 pixels, you may proceed with sensor joint alignment.
To Next Page
Loading...
