When loading the cutting data file in to the iMark software,
the directory in the computer of the loaded graphics file is
displayed in the Status bar.
When “Cutter off line”is displayed, the CE6000 is not
available. Make sure the power of CE6000 is on, and USB
cables are connected correctly. For details, refer to F-Mark
Setup Userʼs manual.
When “Load Media”is displayed, the CE6000Plus is
connected but preparation of CE6000Plus is not finished.
Rise the Set Lever of CE6000Plus, then press the”2”button
on the control panel of CE6000Plus. For details, refer to
F-Mark Setup Userʼs manual.
When “Cutter ready”is displayed, “Cut Test”
and “Start”button are available. Cut operation is possible.
When select “Cut Test” or “Stat”button,”F-Mark feeder off or
not connected software protection not connected” is
displayed,and F-Mark does not work.
Make sure that the the power of F-Mark is on, and USB
cables are connected correctly. For the details, refer to
F-Mark Setup Userʼs manual.
When “Could not run graph”is displayed the USB cable of
camera is may not connected to the USB Hub or multiple
application softwares are may running on the computer.
Make sure that the USB cable of the camera is connected
correctly and close the application softwares other than
iMark software.
Status and Error messages
To Next Page
Loading...
