GRAPHTEC F-Mark - Special Color Plain Cut: Perforation Cuts

- 22 -
When wants to half cuts (Kiss cut) the lines which drawn with magenta and then Die cuts
(perforation cut) the lines which drawn with black.
Please set the iMark software as follows.
Check the “Enable” in the
“Die Cutting”.
NOTICE
 When check the “Enable” in the “Die Cutting”, Die cuts (perforation cut) the lines
which drawn with black.
 Install the Cutter Plunger on the back side.
 For the how to set the Cutter Plunger to the Cutting Plotter CE6000 Plus,
refer to the Userʼs manual of CE6000Plus.
Cutter Plunger
Back side
Special Color “Plain Cut”: half cuts to magenta lines and perforation cuts to black lines