GRAPHTEC F-Mark - Crop Marks Position and Cutting Area

- 6 -
 The minimum distance between the crop mark and the printed graphics is 5 mm.
If the graphics is too close to the crop mark you can get the error:ʻMarker not foundʼ
 Most of digital printer can print up to 5 mm from the border of the sheet, we suggest a minimum
distance of 6mm between the crop mark and the bottom border of the sheet.
Feeding direction
Minimum distance from the front edge to cutting line
Adhesive cut:20mm
(Recommended value:30mm)
Die cutting :25mm
(Recommended value:35mm)
Minimum distance from the top edge to cutting line
5mm (Recommended value:15mm)
Minimum distance from the rear end to cutting line
5mm (Recommended value:15mm)
Minimum distance from the front edge to
the crop marks:40mm
Square Crop Marks 4mm
Minimum distance from the rear end
to the crop marks:20mm
Minimum
distance
from the
bottom end to
the crop
marks :6 mm
Crop Marks position and Cutting area
Spacing between printed graphics
and Crop Marks
Minimum 6mm from the bottom end
Minimum 5mm from the graphics