iMark software window layout
The iMark software allows to handle all the function for the automation of the digital cutting
The install software in on the CD do not need to install any driver , the CE6000Plus is
detected automatically.
For further details refer to the F-Mark Setup Userʼs manual.
The iMark software contains several parameters, most of them are used to set the proper
parameters for the different cutting mode.
Specific parts of the iMark software panel are dedicated to the optical camera and the
mechanical movement on the feeder.
1.Current camera view . 7.Special color panel.(Active when a magenta line is
2.Last optical measurement shot. used on the graphics file.)
3.Calibration commands 8.Die cutting panel.
4.Common commands area. 9.Compensation.
5.Preview area. 10.Mechanical movement adjusting of F-Mark.
11.More options(other functions)
6.Status bar.
To Next Page
Loading...
