GRAPHTEC F-Mark - Graphics File Design

- 2 -
 Graphics layer:Layer on which only the label design are drawn.
When cutting labels with iMark software, it is recommended to create separate layers for each
graphics as shown below.
Graphics file design
 Cut contour layer:Layer on which only contour shapes to be cut by F-Mark are drawn.
 Crop Mark layer:Layer on which only crop marks are drawn.
 When printing a label with printer, save the file the Graphics layer and Crop Mark layer enable
and print it.In this case, if save or print a file with Cut contour layer enabled, the cut contour
image will also printed, disable the Cut contour layer.
 When cutting the contour of the labels with F-Mark, enable the Cut contour layer and Crop
Mark Layer and save the file name separately from the file name to be print.
 These can be done with the function of enable and disable layers of Illustrator and Corel
Draw.
 If edit a file saved in PDF format with and Illustrator or Corel Draw, the outer frame may
automatically generated as the border of the page. This outer frame is unnecessary for label
printing and label cutting and may cause of problem of iMark software, please delete it.