On the right bottom corner of the software window there are two settings for controlling the
movement of the insertion arm.
Uplift :Controls the height of the arm when inserting the sheet.
If media dorps by hitting the edge of”Cutting Mat” or “Grooved of cut” of the
CE6000Plus,increase the Uplift value of iMark software to that the media dose not
hit the edge of “Cutting Mat”or “Groove of cut” of the CE6000Plus.
Input units:0.1mm, Setable values:-100 to 100(-10mm to 10mm).
Insertion :Control how much the suction cups have to push the sheet into the plotter.
If the insertion value is not enough, the media does not reach to Push Roller
of CE6000Plus.And if insertion value is too much, the media will be distorted
and load into the CE6000Plus, and result of cutting may not be properly.
Input units:0.1mm, Setable values:-100 to 155(-10mm to 15.5mm).
To Next Page
Loading...
