GRAPHTEC F-Mark - Table of Contents

iMark software panel layout ...........................................................................1
Graphics file design ......................................................................................2
Layers for printing ......................................................................................3
Layers for Cutting ......................................................................................4
Save file for Cutting ......................................................................................5
Crop Marks position and Cutting area ................................................................6
Open a file for Cutting ......................................................................................7
Status and error messages ...........................................................................8
Basic operations and settings ...........................................................................9
Precautions before cutting ...........................................................................11
Print and Cut alignment ...........................................................................12
Calibration of the F-Mark ...........................................................................13
Compensation .................................................................................................17
Die Cutting .................................................................................................18
Special color panel ......................................................................................20
Special color “Plain Cut”
:half cuts to magenta lines and black lines ..........................................21
Special color “Plain Cut”
:half cuts to magenta lines and perforation cuts to black lines .........22
Special color “Dashed line”
:perforation cuts to magenta lines and half cuts to black lines .........23
Special color “Dashed line”
:perforation cuts to magenta lines and black lines ...............................25
Special color “Blade Creasing” ...........................................................................26
Mechanical movement ......................................................................................28
More options .................................................................................................29
Setting to save the parameter values of the iMark software ...............................32
CONTENTS