GRAPHTEC F-Mark - Basic Operations and Settings

- 9 -
Basic operations and settings
1.Brightness adjustment of the camera:when using media with high reflectance, adjust the
brightness of the camera by this button.
NOTICE: Do not use “Auto” button.
２.Adjustment of cutting position:Cutting position can move in X and Y direction by each
inputted value.
Input units:0.1mm, E.g. 1=0.１mm.
３.“Cutter width” is displayed the width of Push Roller of CE6000Plus.
４.“Pause”:When press “Pause” to stops the cutting. Pressing “Pause” button once, display is
changes from “Pause” to “Resume”. When press the “Resume” to restart the cutting.
NOTICE:
If press the “Pause” button during the cutting, the cutting will be stopped when the
current cutting is completed.
５.“Cut Test”:When press the “Cut Test” to starts one sheet of cuts.
NOTICE:
 Make sure that the adjust the cutting position and cut force by performing the “Cut
Test” before continuous cutting.
 The inputted values and changed parameter values are reflected when “Cut Test” is
performed.
１
2
3
4
5