You can make the cutting on cardboard. Indicatively the usable paperweight goes
from 120 to 350 g/m
2
(35 to 80 lbs).thinner or thicker papers can be tested to
verify the usability.When use the die cutting you have to move the blade Cutter
Plunger in the front side of the Cutting Plotter,In this way, the blade works over
the specific when it perforates the sheet.
NOTICE:
For the how to set the Cutter Plunger to the Cutting Plotter CE6000 Plus
and how to adjust the blade length of Cutter Plunger, refer to the Userʼs
manual of CE6000Plus.
Enable :When perform the “Die Cutting”, put a check mark in “Enable”.
To change the values of “Cut Length” and “Attached”,uncheck “Enable”.
Cut Length :Length to cut with cutter.
Input units:0.1mm, Setable values:1 to 1000(0.1mm to 100mm).
Attach :Length to raise the cutter and leave it without cutting.
Input units:0.1mｍ, Setable values:1 to 100(0.1mm to 10mm).
Speed :It can be set the cut speed at “Die Cutting”.
Setable values :1 to 60 [cm/sec].
Recommended setting values :5 to 15 [cm/sec].
Pass :It can be set the number of times to “Die Cutting” repeatedly.
Setable values :1 to 3.
Cut force :It can be set the cut force at “Die Cutting”.
NOTICE: Setable range of “Cut force” varies depending on the type of
cutting plotter which connected to the F-Mark.
CE6000Plus :1 to 38.
CE6000 :1 to 31.
It can be reduced consumption of the cutter blade, if setting the “Cut Force”
less than 20 and setting the “Pass” to 2.
To Next Page
Loading...
