1:The “File Open” button is load the Cutting data file into the iMark software.
If the cutting data file not saved in Illustrator 8 format, message of “Graphic file not saved
correctly” is displayed.
2:For the “First Marker” input the distance
from the front edge of media to the leftmost
crop mark. The of this value is about 5mm.
If the inputted value for the “Fist Marker” is
extremely different or the crop marks is not in
the center of the camera, the message “Marker
not found” will be displayed.
3:When press the “Open last job” button, the
cutting data file that used be last time is
displayed.
When available is reported beside.
To Next Page
Loading...
