GRAPHTEC F-Mark - Special Color Plain Cut: Half Cuts

- 21 -
Special Color “Plain Cut”: half cuts to magenta lines and black lines
This function is half cuts (kiss cut) to lines which drawn with 100% magenta and then half cuts
to lines which drawn with black.
Speed :It can be set the cut speed when cutting to lines which drawn with 100%
Magenta.
Setable values :1 to 60 [cm/sec].
Cut force :It can be set the cut force when cutting to lines which drawn with 100%
Magenta.
NOTICE: Setable range of “Cut force” varies depending on the type of
cutting plotter which connected to the F-Mark.
CE6000Plus :1 to 38.
CE6000 :1 to 31.
Uncheck the “Enable” in the
“Die Cutting”.
NOTICE
 When uncheck the “Enable” in the “Die Cutting”, half cut the lines which drawn with
black.
 Install the Cutter Plunger on the back side.
 For the how to set the Cutter Plunger to the Cutting Plotter CE6000 Plus,
refer to the Userʼs manual of CE6000Plus.
Cutter Plunger
Back side