GRAPHTEC F-Mark - Save File for Cutting

- 5 -
Corel Draw Export
To save the cutting contour graphics with the Corel Draw, exporting it to EPS format.
When exporting,enable the check box of “Selection only ”, and select the contour and crop
marks and save them.
When saving cutting graphics with A3,SRA3,Extended A3,
save the graphics in horizontal (landscape) view.
 iMark software is not necessary to use specific line widths or specific colors when creating
cutting line.
 Make sure to set the crop marks at the bottom of the graphics.
 iMark software supports all versions of Illustrator and Corel Draw.
 iMark software the magenta lines will be treated specially.
Save file for Cutting
When saving cutting graphics with A4,
save the graphics in vertical (portal) view.
Adobe Illustrator export
To save the cutting contour graphics with the Illustrator,
enable the Cut contour layer and Crop Mark layer and save
with Illustrator 8 format.
When naming the cutting contour graphics file,
save it as a file name different from the printing graphics
file name as in the example below.
E.g. Printing graphics file:Label:ai
Cutting graphics file:Label_Contour.ai
NOTICE
iMark software cannot be load the file name of 2byte
characters,use the file name of alphabet and number.