GRAPHTEC F-Mark - Precautions Before Cutting

- 11 -
 Make sure that the to adjust the cutting positon and cut force by performing the “Cut Test”
before continuous cutting
 When using labels media, perform the test cut to confirm that the length of the cutter blade
is correct and that the label is correctly peeled off from the media.
 The cutter blade gradually wears out each time media cutting. After a lot cutting, please
check the cut quality.
 When the cutter blade is new the cut force setting for an adhesive media may vary from 6
to 9.
 If set the cut force higher than 14, the warning message is displayed as “Cut force to
high-Continue? ”when press the “Cut Test” or “Start”. It is an informative message, press
“OK”to continue. If using a standard adhesive media, when exceed the cut force of 14, it is
time to replace the cutter blade or at least to check if you have a spare on to replace soon.
NOTICE
For the how to set the Cutter Plunger to the Cutting Plotter CE6000Plus and how to
adjust the blade length of Cutter Plunger, refer to the Userʼs manual of CE6000Plus.
Precautions before Cutting