6.”Cut force”:”Cut force” is can be change the cut force of Cutting Plotter.
NOTICE:
Setable range of “Cut force” varies depending on the type of cutting plotter which
connected to the F-Mark.
CE6000Plus :1 to 38.
CE6000 :1 to 31.
7.“Cut blank labels”:When check the “Cut blank labels”, the F-Mark can cutting with out reading
the crop marks.
NOTICE
Crop Marks are not read when cutting with this mode, but crop marks are required for
data of cutting contour graphics.
8.”Start”:The “Start” button lanches the cutting. And the number of cut sheet is displayed on
“Count”.
9.ʻEnter copiesʼ:When check the “Enter copies”, it can be input the number of copies in the
“Copies”. After inputting the number of copies, performed continuous cut by “Start” button,
cutting for the number of inputted in “Copies” will start.
NOTICE
If press “Start”button without checking “Enter copies”,and start cutting,the cutting will
continue until the media runs out.
To Next Page
Loading...
