GRAPHTEC F-Mark - Special Color Dashed Line: Perforation Cuts

- 25 -
Check the “Enable” in the
“Die Cutting”.
NOTICE
 When check the “Enable” in the “Die Cutting”, Die cuts (perforation cuts) the lines
which drawn with black.
 Install the Cutter Plunger on the front side.
 For the how to set the Cutter Plunger to the Cutting Plotter CE6000 Plus,
refer to the Userʼs manual of CE6000Plus.
Cutter Plunger
Front side
Special Color “Dashed line”:perforation cuts to magenta lines and black lines
When wants to Die cuts (perforation cut) the lines which drawn with magenta and then Die cuts
(perforation cut) the lines which drawn with black.
Please set the iMark software as follows.