The input values of each parameter in the iMark software are classified into “to be Saved”,
“Saved for each file name”, and “Not Saved” according to parameter.
1.Parameters for adjustment for cutting position.
The inputted values are saved after pressing the
“Start” button.
When press the “Start” button, the display of
inputted values are reset to zero.
2.First Marker
The inputted value is saved after pressing the
“Start” button.
3.Uplift / Insertion
The inputted values are saved after inputted.
4.Parameter for calibration result,
Current values Delta X / Delta Y.
These values are saved after calibration,
however, when press the “Start” button after
inputting the values in the “Adjustment of cutting
position”, the values of Delta X and Delta Y will be
increased or decreased depending the inputted
values in the “Adjustment of cutting position”.
To Next Page
Loading...
