GRAPHTEC F-Mark - Special Color Dashed Line: Perforation and Half Cuts

- 23 -
Special Color “Dashed line”:perforation cuts to magenta lines and half cuts to black lines
This function is Die cuts (perforation cut) to lines which drawn with 100% magenta and then
half cuts (kiss cut) to lines which drawn with black.
Cut Length :Length to cut with cutter.
Input units:0.1mm, Setable values:1 to 1000(0.1mm to 100mm).
Gap :Length to raise the cutter and leave it without cutting.
Input units:0.1mｍ, Setable values:1 to 100(0.1mm to 10mm).
Speed :It can be set the cut speed when cutting to lines which drawn with 100%
Magenta.
Setable values :1 to 60 [cm/sec].
Cut force :It can be set the cut force when cutting to lines which drawn with 100%
Magenta.
NOTICE: Setable range of “Cut force” varies depending on the type of
cutting plotter which connected to the F-Mark.
CE6000Plus :1 to 38.
CE6000 :1 to 31.
Uncheck the “Enable” in the
“Die Cutting”.