The Y adjustment next to the preview window
allows set the vertical direction of cutting position.
Increasing the Y move the cutting positon upwards.
Decreasing the Y move the cutting position
downwards.
The X adjustment allows set the the horizontal
direction of cutting position.
Increasing the X move the cutting positon
rightwards.
Decreasing the X move the cutting position
Leftward.
The input unit is tenth of one mm
E.g. Inputted value is 10=1mm
The adjustment is necessary the first time install the F-Mark, and when changing the media size,media
type, cut design,and disconnect the F-Mark from the CE6000, and disconnect the iMark software.
When click the “Start” button, the inputted values for X adjustment and Y adjustment becomes “0” after
saving the inputted values.
Although the values of X adjustment and Y adjustment can be input during the cutting, the inputted
values becomes valid from next sheet.
E.g. If the result of cutting is 0.5 mm below the printed image as shown below, input the 5 to Y
adjustment and move the cutting position 0.5mm above.
NOTICE
Depending on the media types and performance of equipment, the adjustment values X and Y
may not be 1=0.1mm, adjust the adjustment values of X and Y depending on the cutting result.
To Next Page
Loading...
