GRAPHTEC F-Mark - Page 29

- 27 -
You have to load the sheet with the print face down.
Pay attention to place the side with the crop marks
on the camera side.
The minimum distance of the cut
path from the right border is 25mm
The distance of the crop mark to the
right border must be 20mm or less
How to loading the media into the F-Mark at “Blade Creasing” mode.
Cutting area at the ”Blade Creasing” mode.
Speed :It can be set the cut speed when cutting to lines which
drawn with 100% Magenta.
Setable values :1 to 60 [cm/sec].
Cut force :It can be set the cut force when cutting to lines which
drawn with 100% Magenta.
NOTICE: Setable range of “Cut force” varies
depending on the type of cutting plotter which
connected to the F-Mark.
CE6000Plus :1 to 38.
CE6000 :1 to 31.
Multiple :It can be set the number of times to repeat the
“Blade creasing” cut.
Setable values :1 to 5
Spacing :It can be set the spacing between the cut lines when
repeating the “Blade creasing” cut.
Input units :0.1mm
Satable values :1 to 20 (0.1mm to 2mm)