3-16
Settings and Measurement
Switching displays
Analog and logic/pulse can be switched as shown below.
Analog settings
This screen allows you to set conditions for analog signals.
CHECKPOINT
ALL and Span All Settings are set only for the currently displayed group (per 10 channels).
(1)-1 Input
Selects input conditions.
(1)-2 Range
Selects the range of signal input to be measured.
・Display Logic/Pulse Data
・Display Analog Data
Selection items Description
Off No signal will be measured.† No waveform/digital display will be performed.
DC Used for measuring direct-current voltage.
TEMP Used for measuring temperature.
RH Used for measuring humidity with the humidity sensor B-530.
Voltage range will be set to 1 V. No EU settings are allowed.
Input settings Description
DC 20, 50, 100, 200, 500 mV, 1, 2, 5, 10, 20, 50, 1-5 V
TEMP TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S, TC-N, TC-W
Pt100, JPt100, Pt1000
RH No selection available
To Next Page
Loading...