3-37
Settings and Measurement
(7)-2 About the Macro
Interface commands for MT100 can be described in a text file and read in. MT100 will operate as
described in this file.
<Macro operation flow>
Macro description example (file name: xxx.GMA)
CAUTION
Refer to the “Interface Command Table” for details on commands supported by MT100 on a separate sheet.
The "Interface Command Table" is included in the CD.
Supported commands are limited to those relative to MT100 settings.
Read in commands cannot be used.
Select the macro file and run the file.
・Macro file name:
・Execute Macro:
MT100 executes the commands
as described in the macro file.
Create a macro file using a text editor on your PC
(save the file with extension "GMA").
Copy this file to a USB memory, and then connect
the USB memory to MT100
To Next Page
Loading...