3-38
Settings and Measurement
(8) Interface settings
This menu is used to specify conditions for PC connection.
(8)-1 Interface
This section allows you to set the new line code to use when controlling the PC connection with the
interface commands.
(8)-2 USB Settings
Sets the USB ID number of MT100.
Specify a number from 0 to 9.
When multiple devices are controlled from a single PC, make sure each device is assigned to a different
ID number.
CAUTION
You must restart MT100 after any change is made to a setting value.
Changes are applied upon restart.
(8)-3 TCP/IP Settings
Sets values to establish an Ethernet connection.
CAUTION
You must restart MT100 after any change is made to a setting value.
Changes are applied upon restart.
Items Settings 1 Settings 2 Selections available
Interface
New Line Code CR+LF, LF, CR
USB Settings USB ID 0 to 9
TCP/IP Settings IP Address 0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
Subnet Mask 0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
Port Number 1024 to 65535
Gateway 0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
DNS Address 0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
Setting items Description
New Line Code CR+LF Starts a newline with CR+LF code.
LF Starts a new line with LF code.
CR Starts a new line with CR code.
Setting items Description
IP Address Sets the IP address of MT100 (0 to 255 . 0 to 255 . 0 to 255 . 0 to 255).
Subnet Mask Sets the IP subnet mask of MT100 (0 to 255 . 0 to 255 . 0 to 255 . 0 to 255).
Port Number Sets the port number of MT100 (1024 to 65535).
Gateway Sets the gateway of MT100 (0 to 255 . 0 to 255 . 0 to 255 . 0 to 255).
DNS Address Sets the DNS address of MT100 (0 to 255 . 0 to 255 . 0 to 255 . 0 to 255).
To Next Page
Loading...