KARRERA K-FRAME — User Manual 145
About eDPMs
Recalling and editing eDPM timelines from the Master E-MEM timeline is
truly independent and does not effect the keyframes in the eDPM. Inserting
keyframes in the Master E-MEM’s eDPM sub-level timeline creates a key
-
frame which is a ‘proxy’ to drive the eDPM’s timeline.
• When running an eDPM timeline from the Master E-MEM timeline,
pauses on the eDPM side are ignored.
• Start delays on the Master (Switcher) side are executed before eDPM
timeline.
eDPM Partitioning
The eDPM partition boundary is a sub-level in the eDPM Primary partition.
Figure 82 shows the Select All, EDPM Pri and EDPM Sec, and PART buttons.
These buttons are used to enable/disable the partition settings and control
the Channel settings in the Picture, Combiner menu.
Note Unlike Master E-MEM Part level, the PART in eDPM is a sub-level of eDPM
Primary and cannot be enabled unless eDPM Primary is also enabled.
Figure 82. eDPM Partitions
In the Control Panel, the eDPM Primary and Secondary partitions are avail-
able via the eDPM Pri/eDPM Sec buttons in the Master E-MEM area.
To Next Page
Loading...
