GRASS VALLEY KARRERA K-FRAME - Setting up a Lever Arm Transition; Performing a Lever Arm Transition

KARRERA K-FRAME — User Manual 237
Setting up a Lever Arm Transition
Figure 129. Transition Area
Setting up a Lever Arm Transition
1. Select the next transition button(s) for the element(s) involved (Bkgd,
Key
1-6, Key Prior.). Selecting one element button disables any others
selected. Holding down one button while pressing another selects both
elements, allowing all the transition elements to be activated if desired.
2. Select the type of transition (Mix, Wipe 1/Wipe 2, or User Transitions).
3. Select any new sources involved in the transition:
• If performing a background transition, select the new source to
transition to on the B bus.
• If you are transitioning in a new key, select that new source on the
key bus.
• If you are changing key priority, specify a new key priority in the
Keyer Priority menu.
4. If desired, select a transition modifier (Trans PVW or Preset Black).
Performing a Lever Arm Transition
1. Move the transition lever arm. The picture will transition only the
elements selected. Other elements will remain unchanged.
Mix
Transns
PVW
Ps t
BLK
Key
1
Key
2
Key
3
Key
4
Key
5
Key
6
Key 1
Transns
Key 2
Transns
Key 3
Transns
Key 4
Transns
Key 5
Transns
Key 6
Transns
CutCut
AutoAuto
Key
Prior
Wipeipe
1
Wipeipe
2
Userer
1
Userer
2
8805_05
Main Transition Controls
(3 Groups)
Other Transition
Controls (2)
Keyer Transition
Controls
(6)
Transition
Lever Arm