OCP 400 Operational Control Panel User’s Guide (v12.0) 19
Chapter 3 - Setup
Chapter 3
Setup
3.1 Installation
1. Connect a power supply unit to the power input connector of the OCP 400.
2. Connect the Ethernet cable from the camera control (C2IP) network to the Ethernet
connector of the OCP 400.
It is recommended to use Grass Valley’s LDK 5903 power supply unit with the OCP 400.
3.2 Checking system status
To check that XCU/Base Station and camera are connected correctly go to the Diag menu in
the setup menu.
– Push the SETUP button to open the menu.
– Push the SELECTION button to choose the Diagnostics menu. The diagnostics menu
appears. Push NEXT and PREV to navigate through the different pages.
Menu Selections Function Level Possible values
Setup DIAG Go to the Diagnostics menu S
OCP Go to the OCP setup menu S
BS Go to the XCU/Base Station
setup menu
S
CAM Go to the Camera setup menu S
To Next Page
Loading...