GRASS VALLEY OCP 400 - Setting Up the OCP

20 OCP 400 Operational Control Panel User’s Guide (v12.0)
Chapter 3 - Setup
3.3 Setting up the OCP
Various aspects of the OCP can be set to suit your work methods. To open the menu which
lets you set up these preferences proceed as follows:
– Push the SETUP button to open the menu.
– Push the SELECTION button to choose the OCP submenu.
– The first page of the OCP setup menu appears. Use the NEXT button to find the page
with the item you wish to change and then select this item with its correpsonding
selection button.
Menu Selections Function Level Possible values
Diagnostics
page 1
Camera Camera type number S No camera, [Camera Type]
Gen Lock GenLock Status S Locked, Not Locked, No sync
BS Type XCU/Base Station type S LDK4502 .. LDK 4430
Cable Triax status diagnostics S No camera, DC Power, Short, etc
Diagnostics
page 2
Cam Pack. Camera package version S Last 4 digits of Package 12nc
Version Camera package version S v0x.0y
BS Pack. XCU/Base Station package
version
S Last 4 digits of Package 12nc
Version XCU/Base Station package
version
Sv0x.0y
Diagnostics
page 3
Cam SW Camera Software 12NC S
Status Camera Software Status S
BS SW XCU/Base Station Software
12NC
S
Status XCU/Base Station Software
Status
S
Diagnostics
page 4
OCP Appl Application software version S v04.01
OCP BootSw Boot software version S vXX.XX
OCP FirmW Firmware version S vXX.XX
OCP Type OCP device type S OCP 400/00 or OCP 400/10
Diagnostics
page 5
Ethernet MAC OCP Ethernet MAC address S Mac-address is displayed as:
XX:XX:XX:XX:XX:XX
Address
Link Type Ethernet link speed S 10 Mbit/100 Mbit Full/Half Duplex
Link State Ethernet connection status S Connected / Not Connected
Diagnostics
page 6
Ser Recv F
Ser Sent F
Frame Err F
Sum Err F