GRASS VALLEY OCP 400 - Display and Button Brightness; Iris (Joystick) Setup; Clock; Default Values

24 OCP 400 Operational Control Panel User’s Guide (v12.0)
Chapter 3 - Setup
3.3.4 Display and button brightness
The text brightness and contrast of the display and the brightness of the low and high levels of
the button lights can be set in the OCP setup menu. Select the item you wish to change and
then use the assignable rotary control to adjust its value.
3.3.5 Iris (joystick) setup
The range over which the iris opening can be controlled by the joystick and its sensitivity are
set in the Iris submenu of the OCP Setup menu. The direction of control can also be set in the
IRIS submenu.
3.3.6 Clock
The time for the internal clock is set in the CLOCK submenu of the OCP setup menu. The
assignable rotary control is used to set the hours, minutes and seconds.
3.3.7 Default values
The default values of the OCP are stored in the OCP and are restored when the Reset OCP
item is selected. When the OCP is powered up or reset, a connection to the last camera
number used is made.
The default values for the camera and XCU/Base Station parameters are stored in the camera
and XCU/Base Station default files. The camera parameters and their values that are shown on
the OCP depend on the camera connected to OCP. If you select a different camera number, a
different set of parameters and values can appear.
Menu Selections Function Level Possible values
Iris setup Iris Mode Select Iris joystick mode S Normal, Reverse
Range Set Iris joystick control range S 0..99
Center Set Iris joystick control center S 0..99
IRIS CAL Calibrate joystick S Move the joystick to the most
upper and lower position.
Menu Selections Function Level Possible values
Clock
page 1
Hour Hour selection function F 0..23
Minute Minute selection function F 0..59
Second Second selection function F 0..59
-
Clock
page 2
Year Year selection function F 2000..2099
Month Month selection function F <months>
Day Day selection function F 0..31
-