GRASS VALLEY OCP 400 - Using Files

34 OCP 400 Operational Control Panel User’s Guide (v12.0)
Chapter 4 - Operation
4.3 Using files
4.3.1 Storing and recalling scene files
The scene file function is used for storing and recalling scene settings for the camera. Four
scene files can be stored in memory positions 1 to 4 of the camera.
• To recall a scene file, push the FILES button to open the menu.
• Select a memory position 1 to 4. The values stored in this file are then recalled.
To create a scene file, set up the values for all the functions on the OCP, push the FILES button
to open the menu. Push the NEXT button to open the store page and then select a memory
position. The values are stored in this position.
☞
Note
☞
Note
When a scene file is recalled, the values only take effect if the camera is not On Air.
Menu Selections Function Level Possible values
Scene
files 
page 1
RECALL 1 Recall Scene File 1 S Ready, Failed
RECALL 2 Recall Scene File 2 S Ready, Failed
RECALL 3 Recall Scene File 3 S Ready, Failed
RECALL 4 Recall Scene File 4 S Ready, Failed
Scene
files 
page 2
STORE 1 Store Scene File 1 S Ready, Failed
STORE 2 Store Scene File 2 S Ready, Failed
STORE 3 Store Scene File 3 S Ready, Failed
STORE 4 Store Scene File 4 S Ready, Failed