OCP 400 Operational Control Panel User’s Guide (v12.0) 7
Chapter 1 - Introduction
Chapter 1
Introduction
1.1 Application
The OCP 400 is a compact operational control panel for all Grass Valley cameras. The user
interface is designed for convenience, with menu accessible functions for detailed set-up and a
clear display of functions and values.
The OCP 400 operates within the Ethernet-based C2IP camera control network using TCP/IP
as its communication protocol. The OCP 400 not only controls all camera functions, it can also
be used to change the menu values of the Grass Valley XCU/Base Stations. Extensive set-up
parameters for the OCP 400 itself, the camera and XCU/Base Station are available.
1.2 Features
• Uses IP connectivity: off-the-shelf IT-network infrastructure over standard IEEE 802.3 10/
100 Mb Ethernet;
• Supports C2IP camera control interface protocol supported by all Grass Valley cameras;
• Integrates with other Grass Valley broadcast products and network tools;
• provides remote diagnostics for camera and transmission operation;
• Improved ergonomics and large flexibility: comfortable, slimline and clean design with
hard style buttons;
• Tilted backlit LCD display for maximum readability;
• Very clear and dimmable On Air and ISO indicators on board;
• Easy setup and camera number selection;
• Configurable access levels;
• Multiple camera support for 3D operation;
• Adjustable joystick tension to accommodate wide variety of applications from mobile unit
to outdoor use;
• Full and partial locking of the operation panel;
• Smart card for storing operational and technical parameters of the camera system.
To Next Page
Loading...