Operation procedure:
1. Press [REF] to display the menu “REF WAV”.
2. Select the “Signal source” as CH1or CH2.
3. Revolve the vertical [POSITION] and knob [Volt/div] to regulate the vertical position
and the gear of the reference waveform.
4. Select “REF A” or “REF B” as storage location of the reference waveform.
5. Press “Save” to save the current screen waveform as a waveform reference.
6. Select “REF A ON” or “REF B ON” to recall the reference waveform, as shown in figure
2-23.
The waveform cannot be saved as reference waveform if it is displayed in an X-Y mode.
The horizontal position and gear of the waveform cannot be regulated at a reference
waveform state.
To Next Page
Loading...
