61
Trunked Mode Analysis Display
Motorola 3600 baud control chan-
nel
qq% SID:ssss Stt
where qq=decoding quality of the con-
trol channel data, SID=System ID, and
S=Site Number
EDACS control channel
qq% S:ss h/H s/S a/A
where qq=decoding quality of the con-
trol channel data, S=Site ID, h/H=not
home site/is home site, s/S=not SCAT
site/is SCAT site, a/A=not Aux CC/is
Aux CC
LTR home repeater
HR:hh A-HH-GGG
where HR=the home repeater number
of the tuned frequency, A-HH-GGG=the
Area, Home Repeater and Group ID of
the LTR talkgroup
Motorola analog voice channel
VC: lsTGID-nnnnn
where lsTGID shows the decoded talk-
group ID data from the lowspeed data
stream
Please note that the analog lowspeed
data protocol does not provide error
correction, and some false “VC: lsTGID”
readings should be expected.
You may wish to use the PSR-310's Tune LED feature to obtain a visual in-
dication of signal strength using the tri-color LED. To activate the Tune LED,
press PGM, then the
GLOB
softkey. Press the
6
key until
Tune
LED:
Off
appears in the display. Use the
34
keys to toggle Tune LED on or off,
then press the
SAVE
softkey to save your changes to the radio's configura-
tion memory.
Using dedicated Limit and Service search modes
The SRCH key provides immediate access to the dedicated search modes
of your PSR-310. Pressing the SRCH key cycles through each search mode
in this order: Limit, Railroad, Public Safety, Aircraft, Ham, CB, Marine, and
FRS/GMRS/MURS/DOT.
LMIT Search Mode
Your scanner's dedicated LMIT search mode provides you with the ability
to create a limit search with a search frequency range between upper and
lower limit frequencies that you specify and perform the limit search directly
without creating a new LMIT object. You can then monitor that frequency
range for transmissions.
To Next Page
Loading...
