79
HINT: You can restore all GLOB settings to their defaults without affecting
your programmed objects. Power cycle the radio, then press 0, then 2 dur-
ing the welcome message display. Press ENT to confirm the GLOB param-
eter reset.
GLOB Parameter Options Description
CONTRAST 1-7
Sets LCD contrast. Use
34
keys
on 5-way pushbutton pad.
Owner SEL
Enters sub menu to set Welcome
Message text display.
Font Normal, Bold
Sets displayed font. Use
34
keys
on 5-way pushbutton pad.
Clone Send SEL
Press SEL to send data using
clone mode
Alert Mode Both, Tone, Light, Off
Controls the ALERT LED and Au-
dible Alarm behavior. Both allows
the LED and Tone. Tone allows the
audible alarm only. Light allows
the LED only. Off deactivates the
ALERT LED and Audible Alarm fea-
ture.
Sound Mode On or Stlth Controls all radio beeps.
Key Beeps On or Off Controls key beeps.
Light Mode
Norml, Key, Ignre, On,
Stlth
Controls the backlight operation.
Norml (Normal) uses the back-
light key on the keypad. Key acti-
vates the backlight when any key
is pressed. Ignore activates the
backlight when a key is pressed,
and that key's normal function is
ignored if the backlight is off when
it is pressed. On causes the back-
light to remain on all the time. Stlth
(Steath) disables the backlight.
Light Area Both, LCD, Keybd
Controls what area is illuminated
when the backlight is on. Both il-
luminates the LCD and the keypad,
LCD illuminates the display only.
Keybd (Keyboard) illuminates the
keypad only.
Light Secs 1-99 seconds
Controls the amount of time the
backlight remains on for Normal,
Key and Ignore light modes
To Next Page
Loading...
